have arduino imported, and RF24 compiling

main.cpp

@@ -0,0 +1,79 @@
+#include <util/delay.h>
+#include <avr/io.h>
+#include <stdio.h>
+#include <stdarg.h>
+#include <util/setbaud.h>
+#include <Arduino.h>
+
+#include <SPI.h>
+#include <nRF24L01.h>
+#include <RF24.h>
+#define CE_PIN 7
+#define CSN_PIN 8
+
+#define LED PORTD2
+#define PULL PORTD3
+#define ENABLE PORTD5
+#define DIRECTION PORTD6
+
+
+void uart_init() {
+    // Upper and lower bytes of the calculated prescaler value for baud.
+    UBRR0H = UBRRH_VALUE;
+    UBRR0L = UBRRL_VALUE;
+
+    // Configure data frame size to 8-bits.
+    UCSR0C = _BV(UCSZ01) | _BV(UCSZ00);
+
+    // Configure to enable transmitter.
+    UCSR0B = _BV(TXEN0);
+}
+
+void uart_putchar(char c) {
+    // Wait until the register to write to is free.
+    loop_until_bit_is_set(UCSR0A, UDRE0);
+
+    // Write the byte to the register.
+    UDR0 = c;
+}
+
+void uart_putstr(char *data) {
+    // Loop until end of string writing char by char.
+    while(*data){
+      uart_putchar(*data++);
+    }
+}
+
+
+const char thisSlaveAddress[5] = {'R','x','A','A','A'};
+
+int main(void) {
+    digitalWrite(10, 10);
+
+    RF24 value(CE_PIN, CSN_PIN);
+    uart_init();
+
+	DDRC &= ~(1<<0); // Input
+	PORTC |= (1<<0); // Enable Internal Pull Up (Setting it to HIGH)
+
+//    DDRD |= (1 << ENABLE);
+    DDRD = DDRD | 0xFC;
+   
+    PORTD |= _BV(ENABLE);
+    PORTD |= _BV(DIRECTION);
+   
+    for(;;){
+            
+//        uart_putstr("hello\n");
+        _delay_ms(400);
+        PORTD |= _BV(PULL);
+        _delay_ms(400);
+        PORTD &= ~_BV(PULL);
+    
+        uint8_t port_value = 2;
+//        port_value = PINC & (1 << 0);
+        uart_putchar((char)port_value);
+//        uart_putchar((char)'\n');
+    }
+
+}